Started working on the buttons for the Plain Pillows. Found
this website with instructions to create custom knitted button covers.
I made a few changes and am pleased with the results!
Following the instructions using the same sized needle as the actual pillow (size 6) created a piece much too big, both in overall size and stitch size.
So I reduced the needle to a size 2, and also reduced the number of "knit even" rows. Voila!
After the first button my fingers were pinched and sore, so I amended the instructions a little further:
CO2
ROW 1: K1, M1R, K1, Ktbl
ROW 2: P1, M1, P2, M1, P1 (used cable needle to help pickup stitches)
ROW 3: K1, M1, K4, M1, K1
ROW 4: P1, M1, P6, M1, R1
There are 10 stitches on the needle.
 |
| Hole "repaired" |
ROW 5: K
ROW 6: P
Repeat rows 5 & 6
ROW 9: K2tog, K6, K2tog
ROW 10: P2tog, P4, P2tog
ROW 11: K2tog, K2, K2tog
ROW 12: P2tog, P2tog
Don't BO. Just pull yarn through final two stitches.
Here's a comparison of the final button with the first button which used the original instructions:
And finally onto the construction of the button:
--Place the button front on the WS of the fabric
--Hook the fabric around the teeth of the button front, then pop in the back. Actually I found that I could skip this step. Because the yarn is so wooly and thick the teeth were enough to keep the fabric on the button. I didn't get the buttons with the tool to assist with applying the back. I would recommend not skimping and to get the kit.